Pettit Paint Ultima SR-60, Black, Gallon

• New.

Pettit Ultima SR-60 Ablative Antifouling PaintPettit Ultima SR-60 delivers exceptional, multi-season, dual-biocide performance by combining the highest ablative copper load (60%) with slime resistant Irgarol. Its ablative surface wears away over time, reducing build up. Utilizes the same proven formula as Ultima Pro from our Pro Coatings line. Note: Due to extremely high copper load, some variations in color and finish may occur. Use 185 Thinner. Highest copper load available in ablative bottom paints (60%) Dual Biocide, Multi-Season Protection Contains 54% more copper than Micron Extra at a lower cost Same proven formula as "Ultima Pro" from our Professional Coatings lineSpecifications: Finish: Flat Coverage: 400 ft²/gal. Number of Coats: 1 minimum per season with additional coats at waterlineAssociated Products:Pettit Ablative Thinner: For brushing, rolling, clean-up and spray application. ***AVAILABLE FOR GROUND SHIPPING ONLY, WITHIN THE CONTINENTAL 48 STATES*** How To ApplyAPPLICATION DATA METHOD: Brush, Roller, Airless or Conventional Spray NUMBER OF COATS: 2-3 minimum DRY FILM THICKNESS PER COAT: 2 mils (3.6 wet mils)COVERAGE: 400 sq. ft/gal. APPLICATION TEMP: 50 F. Min. / 95F. Max.THINNER: 185 Ablative ThinnerDRY TIMES:TempTo TouchTo RecoatTo Launch90F1 HR3 HR8 HR70F2 HR6 HR16 HR50F3 HR12 HR48 HRPREVIOUSLY PAINTED SURFACES: If the previous coating is in good condition, thoroughly sand with 80 grit paper then solvent clean with 120 Brushing Thinner to remove residue. Apply two finish coats of Ultima SR-60. If the previous coating is soft or in poor condition, remove to the bare surface by sanding or using a paint & varnish remover. Proceed with appropriate bare system as described below. Old tin copolymers must be removed or sealed with 6627 Tie-Coat Primer before applying Ultima SR-60. BARE FIBERGLASS: All bare fiberglass, regardless of age, should be thoroughly cleaned with 92 Bio-Blue Hull Surface Prep or de-waxed several times with